4. Remove the fan off the chassis.
Identifier GUID-4C1D64DC-157D-4048-8528-59A88A030C7C
Status Released
Installing the chassis fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the chassis fan and provides a visual representation of the installation procedure.
Steps
1. Align the slots on the fan with the rubber grommets on the chassis.
NOTE:
The replaceable fan may have tabs inserted in the grommets slots to block the grommets slots and to avoid
incorrect installation on the fan. Service fan will have tabs plugged on one side to avoid incorrect installation of the
fan.
Removing and installing components 25
To Next Page
Loading...
