Steps
1. Slide the power-supply unit into the chassis until the securing tab snaps into position.
2. Route the power cable through the routing guides on the chassis and connect the power cables to their respective connectors on the
system board.
3. Replace the three screws (#6-32) that secure the power-supply unit to the chassis.
4. Slide and align the screw holes on the power-supply unit cover with the screw holes on the chassis.
NOTE:
Only the computer with clear doors are shipped with power-supply unit cover. This step is applicable only for
computers shipped with power-supply unit cover.
5. Replace the two screws (#6-32) that secure the power-supply unit to the chassis.
Next steps
1. Install the 3.5-inch hard drive.
2. Install the graphics card.
42
Removing and installing components
To Next Page
Loading...
