Post-requisites
Replace the right-side cover.
Clearing CMOS Settings
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Remove the right-side cover.
Procedure
1 Remove the jumper plug from the password jumper-pins (PSWD) and connect it to the CMOS jumper-pins.
2 Wait for 5 seconds and then replace the jumper plug to its original location.
Post-requisites
Replace the right-side cover.
Flashing the BIOS
You may need to ash (update) the BIOS when an update is available or when you replace the system board.
114
System setup
To Next Page
Loading...
