Replacing the 3.5-inch hard drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Place the hard drive in the hard-drive bracket.
2 Align the screw holes on the hard drive with the screw holes on the hard-drive bracket.
3 Replace the four screws (6-32UNCx3.6) that secure the hard-drive bracket to the hard drive.
4 Slide the hard-drive assembly into the slot on the side-chassis.
5 Replace the two screws (6-32UNCx3.6) that secure the hard-drive assembly to the side-chassis.
6 Connect the data cables and the power cables to the hard drive and place the computer in an upright position.
18
Replacing the 3.5-inch hard drive 31
To Next Page
Loading...
