Removing the 3.5-inch hard drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
Remove the right-side cover.
Procedure
1 Lay the computer on the left side and disconnect the power cable from the hard drive.
2 Disconnect the data cable from the hard drive.
3 Remove two screws (6-32UNCx3.6) that secure the hard-drive assembly to the side-chassis.
4 Lift the hard-drive assembly out of the slot on the side-chassis.
5 Remove the four screws (6-32UNCx3.6) that secure the hard-drive bracket to the hard drive.
6 Lift the hard drive o the hard-drive bracket.
17
Removing the 3.5-inch hard drive 29
To Next Page
Loading...
