Replacing the graphics card
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Procedure
• Post-requisites
Procedure
1 Align the graphics card with the slot on the chassis.
2 Align and place the graphics card into the slot on system board and press down rmly until the graphics card snaps into place.
3 Replace the screw (6-32UNCx3.6) that secures the graphics card to the chassis and place the computer in an upright position.
Procedure
Only with computers shipped with full-length graphics card
1 Align the graphics card with the slot on the chassis.
2 Align and place the graphics card into the slot on system board and press down rmly until the graphics card snaps into place.
3 Replace the two screws (6-32UNCx3.6) that secure the graphics card to the chassis.
4 Connect the graphics-card cable to the graphics card.
24
Replacing the graphics card 43
To Next Page
Loading...
