Replacing the solid-state drive
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
• Procedure
• Post-requisites
Procedure
1 Adhere the thermal pad to the system board.
2 Align the notch on the solid-state drive with the tab on the solid-state drive slot.
3 Insert the solid-state drive at a 45-degree angle into the solid-state drive slot.
4 Press the other end of the solid-state drive down and replace the screw (M2x3.5) that secures the solid-state drive to the system
board.
16
Replacing the solid-state drive 27
To Next Page
Loading...
