Installing the antenna module
1 Insert the antenna module into the slot on the back cover of the tablet.
2 Tighten the M1.6 x 3 screw to secure the antenna module,
3 Un route the antenna cables from the routing channels,
4 Ax the tape and the conductive tapes to secure the antenna cables
5 Install the:
a heat sink
b rear facing camera
c front facing camera
d system fan
e WLAN card
f SSD card
g battery
h display panel
i uSIM/microSD card
NOTE
: uSIM card is installed only on tablets shipping with WWAN module.
6 Follow the procedure in After working inside your tablet.
Removing and installing components
35
To Next Page
Loading...
