Dell Latitude E4200 - Removing the Coin-Cell Battery; Replacing the Coin-Cell Battery

Back to Contents Page
 Coin-Cell Battery
Dell™Latitude™E4200ServiceManual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
Removing the Coin-Cell Battery


1. Follow the procedures in Before Working on Your Computer.

2. Remove the LED cover (see Removing the LED Cover).

3. Remove the keyboard (see Removing the Keyboard).

4. Pry up the coin-cell battery to release the double-sided adhesive tape on the bottom.

5. Lift the coin-cell battery out of the computer.

6. Disconnect the battery cable from the system board.
Replacing the Coin-Cell Battery


1. Connect the coin-cell battery cable to the system board.

2. Insert the coin-cell battery into the computer.

3. If you are re-installing the old coin-cell battery, press down to seal the tape on the bottom.
If you are installing a new coin-cell battery, remove the adhesive backing from the battery and slide the battery under the tab. Press to seal the tape on
the bottom.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1
battery cable
2
LED board cable
3
coin-cell battery


CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.