Dell Latitude E4200 - Removing the Smart Card Reader; Replacing the Smart Card Reader

Back to Contents Page
 Smart Card Reader
Dell™Latitude™E4200ServiceManual
Removing the Smart Card Reader
Replacing the Smart Card Reader
Removing the Smart Card Reader


1. Follow the instructions in Before Working on Your Computer.

2. Remove the service panel (see Removing the Service Panel).

3. Remove the WLAN and WWAN cards (see Removing the WLAN/WiMax Card and Removing a WWAN Card).

4. Remove the memory module (see Removing the Memory Module).

5. Remove the solid state drive (see Removing the Solid State Drive and Cable Assembly).

6. Remove the LED cover (see Removing the LED Cover).

7. Remove the keyboard (see Removing the Keyboard).

8. Remove the module with Bluetooth
®
wireless technology (see Removing the Card With Bluetooth Wireless Technology).

9. Remove the display assembly (see Removing the Display Assembly).

10. Remove the coin-cell battery (see Removing the Coin-Cell Battery).

11. Remove the palm rest assembly (see Removing the Palm Rest Assembly).

12. Remove the system board assembly (see Removing the System Board Assembly).

13. Remove the M2 x 3-mm screw from the smart card reader.

14. Slide the smart card reader to the right to free the tabs from the base assembly, and lift the reader out of the base assembly.
Replacing the Smart Card Reader

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1
smart card reader
2
base assembly
3
screw
4
tabs