Dell Latitude E4200 - Removing the TAA Board

Back to Contents Page
 TAA Board
Dell™Latitude™E4200ServiceManual
Removing the TAA Board
Replacing the TAA Board

Removing the TAA Board

1. Follow the procedures in Before Working on Your Computer.

2. Remove the service panel (see Removing the Service Panel).

3. Pull up on the TAA board to disconnect it from the system board.
Replacing the TAA Board

1. Align the connector on the TAA Board with the connector on the system board, and press the TAA board into place.

2. Replace the service panel (see Replacing the Service Panel).

3. Follow the procedures in After Working on Your Computer.
Back to Contents Page

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTE: The Trade Agreements Act (TAA) board is optional and may not be present in some computers.
1
TAA board
2
system board
3
connector

