Dell Latitude E4200 - Removing a WWAN Card; Replacing a WWAN Card

Back to Contents Page
 WWAN Card
Dell™Latitude™E4200ServiceManual
Removing a WWAN Card
Replacing a WWAN Card


Removing a WWAN Card

1. Follow the procedures in Before Working on Your Computer.

2. Remove the service panel (see Removing the Service Panel).

3. Disconnect the antenna cables from the card.

4. Remove the M2 x 3-mm screw. The card pops up at a 45-degree angle.

5. Slide the card out of the card connector on the system board.
Replacing a WWAN Card

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE: Insert a WWAN card only into the slot labeled WWAN.
1
antenna cables (2)
2
WWAN card
3
screw


1
WWAN card
2
card connector