2. Lower the paddle card into place and press until the paddle card connector is fully seated with audible sound on the system
board connector.
Figure 97. Installing the R1 paddle card
Figure 98. Installing the R4 paddle card
Next steps
1. Install cooling fan cage assembly
2. Install the air shroud.
3. Follow the procedure listed in After working inside your system.
Removing the R3 paddle card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. If required, remove the rear mounting front PERC module.
NOTE: Observe the cable routing before disconnecting the cables.
4. Disconnect the paddle card slimline cable form the backplane.
102
Installing and removing system components
To Next Page
Loading...
