Dell PowerEdge R750xa - Removing the GPU Riser Module Card Holders; Installing the GPU Riser Module Card Holders

Removing the GPU riser module card holders
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the GPU riser module.
NOTE: Your system has either half height (HH) or full height (FH) or without GPU card holder, which is based on the type
of GPU card used.
Steps
Loosen the captive screw and pull out the HH or FH GPU card holder form the GPU riser module.
Figure 119. Removing the HH card holder
Figure 120. Removing the FH card holder
Next steps
1. Replace the GPU riser module holders.
Installing the GPU riser module card holders
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
Installing and removing system components
117