Figure 44. Installing a drive carrier
Next steps
If removed, install the front bezel.
Removing a NVMe drive blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. If installed, remove the front bezel.
3. Remove all drives.
NOTE: All drives need to be installed to their original position.
4. Remove the drive backplane cover.
5. Remove the drive backplane.
CAUTION: For proper system cooling, drive blanks must be installed in all empty drive slots.
NOTE: NVMe drive blank is applicable for the system with x6 NVMe drive configuration.
Steps
Lift the release latch and push the NVMe drive blank out of the drive slot.
50
Installing and removing system components
To Next Page
Loading...
