Installing the VGA port
The procedure to install VGA port on Riser 2 is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the air shroud.
NOTE: VGA port is supported only in slot 4, slot 5 or slot 6 of the expansion card riser.
Steps
1. Open the latch on the expansion card riser and remove the filler bracket from the expansion card riser.
2. Slide the VGA port into the expansion card riser and close the latch.
Figure 129. Installing the VGA port
3. Connect the VGA port cable to the LC rear I/O board.
4. Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
5. Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated
on the system board connector.
6. Tighten the captive screws on the system.
Installing and removing system components
123
To Next Page
Loading...
