Figure 149. Removing the internal USB card
Next steps
1. Replace the internal USB card.
Installing the internal USB card
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the expansion card risers.
Steps
1. Connect the USB key to the internal USB card.
NOTE:
For information on the exact location of internal USB card on system board, see System board jumpers and
connector section.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
138
Installing and removing system components
To Next Page
Loading...
