Dell PowerEdge R750xa - Removing the GPU Riser Module

Figure 104. Installing the custom bracket with three screws
Next steps
1. Install the GPU card.
2. Follow the procedure listed in After working inside your system.
Removing the GPU riser module
The procedure to remove left and right GPU riser module are similar.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. Remove the cooling fan cage assembly.
5. Disconnect the GPU power and signal cables from the system board.
6. Disconnect R1 and R4 paddle cards from the system board.
7. Remove the rear mounting front PERC module.
8. If installed, remove the NVLink sponges.
Steps
1. Press the blue button on the GPU riser module, lift handle comes out of GPU riser module.
2. Use both hands, in one hand hold the lift handle, and in other hold the lifting edges to remove GPU riser module out of the
system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
106 Installing and removing system components