Table 35. Config1-2. R2A + R3 paddle card + GPU riser module right with R1 paddle card + GPU riser
module left with R4 paddle card (with NVbridge) (continued)
Card type Slot priority Maximum number of cards
Broadcom (OCP: 10Gb) Intergrated slot 1
Intel (OCP: 10Gb) Intergrated slot 1
QLogic (OCP: 10Gb) Intergrated slot 1
Broadcom (OCP: 1Gb) Intergrated slot 1
Intel (OCP: 1Gb) Intergrated slot 1
Foxconn (External Adapter) 3, 6 2
Foxconn (External Adapter) 3, 6 2
Inventec (BOSS 1.5) Intergrated slot 1
Removing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
4. If applicable, disconnect the cables from the expansion card or system board.
NOTE: Only Riser 3 and Riser 2 are supported.
Steps
1. Loosen the captive screws on the riser.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components 91
To Next Page
Loading...
