Dell PowerEdge R750xa - Removing a Cooling Fan

Figure 34. Installing the cooling fan cage assembly
Next steps
1. If removed, install the air shroud.
2. Insert the cables into cables access latch and close cable access latch.
3. Connect the cables to system board that pass through the cooling fan cage assembly cable latch.
4. Follow the procedure listed in After working inside your system.
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
Press the orange release tab and lift the cooling fan to disconnect the fan from the connector on the system board.
WARNING: Ensure not to tilt or rotate the cooling fan while removing from the system.
Installing and removing system components 41