Steps
Align the PSU blank with the PSU bay and push it into the PSU bay until it clicks into place.
Figure 158. Installing a power supply unit blank
Removing a power supply unit adapter
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
NOTE: Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Steps
Using a Phillips #1 screwdriver, loosen the screw and remove the power supply unit adapter.
Figure 159. Removing a power supply unit adapter
Next steps
1. Replace the PSU adapter or Install the PSU.
Installing and removing system components
145
To Next Page
Loading...
