Dell PowerEdge R750xa - Optional VGA Port for Liquid Cooling Module

Figure 126. Connecting the serial COM port
Next steps
1. Install the air shroud.
2. Follow the procedure listed in After working inside your system.
Optional VGA port for liquid cooling module
Removing the VGA port
The procedure to remove VGA port from Riser 2 is same.
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove the air shroud.
Steps
1. Loosen the captive screws on the system.
2. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
3. Disconnect the VGA port cable from the liquid cooling (LC) rear I/O board.
Installing and removing system components
121