NOTE: For more information about supported GPU cards and their slot priority, see expansion card installation guidelines.
Steps
1. If installed, remove the NVLink cover from the GPU card.
Figure 117. Removing the NVLink cover
NOTE: Store the NVLink cover for future use.
2. Align the NVLink bridges with the NVLink slot on the GPU cards.
NOTE:
Ensure that the NVIDIA icon on the NVLink bridge is aligned with the NVIDIA icon on the slot 34 and slot 31 GPU
card.
3. Press the NVLink bridges, until firmly seated on the GPU cards.
Figure 118. Installing the NVLink bridges
Next steps
1. Install the GPU riser module.
2. Install the NVlink sponges.
3. Install the rear mounting front PERC module.
4. Follow the procedure listed in After working inside your system.
116
Installing and removing system components
To Next Page
Loading...
