Dell PowerEdge R7615 - Page 111

Figure 73. 12 x 3.5 inch SAS/SATA with APERC11 in Riser 2 and Rear 2 x 2.5 inch SAS/SATA
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 68. 12 x 3.5 inch SAS/SATA with APERC11 in Riser 2 and Rear 2 x 2.5 inch SAS/SATA
Order From To
1 CTRL_SRC_SA1 (fPERC controller
connector)
BP_DST_SA1 (backplane expander signal
connector)
2 SIG_PWR_0 (system board power
connector)
BP_PWR_1 (backplane power
connector)
3 CTRL_SRC_SB1 (fPERC controller
connector)
BP_DST_SA1 and BP_DST_SB1
(backplane expander signal connector)
4 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power
connector)
Installing and removing system components 111