Dell PowerEdge R7615 - Page 122

Figure 84. 16 x 2.5 inch U.2 Gen4 Low Profile with 2 x FPERC11
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 79. 16 x 2.5 inch U.2 Gen4 Low Profile with 2 x FPERC11
Order From To
1 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power
connector)
2 SIG_PWR_1 (system board power
connector)
BP_PWR_1 (backplane power
connector)
3 CTRL_DST_PA1 (fPERC input
connector)
SL4_CPU1_PB2 (signal connector on
system board)
4 CTRL_DST_PB1 (fPERC input
connector)
SL2_CPU1_PB2 (signal connector on
system board)
5 CTRL_SRC_PB1 (fPERC controller
connector)
DST_PA2 and DST_PB2 (backplane
signal connector)
6 CTRL_SRC_PA1 (fPERC controller
connector)
DST_PA1 and DST_PB1 (backplane signal
connector)
7 SL1_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input
connector)
8 SL3_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PB1 (fPERC input
connector)
9 CTRL_SRC_PB1 (fPERC controller
connector)
DST_PA2 and DST_PB2 (backplane
signal connector)
10 CTRL_SRC_PA1 (fPERC controller
connector)
DST_PA1 and DST_PB1 (backplane signal
connector)
122 Installing and removing system components