Dell PowerEdge R7615 - Page 121

Figure 83. 16 x U.2 Gen4 Low Profile
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 78. 16 x U.2 Gen4 Low Profile
Order From To
1 SIG_PWR_2 (system board power
connector)
BP_PWR_1 (backplane power
connector)
2 SIG_PWR_1(system board power
connector)
BP_PWR_1 (backplane power
connector)
3 SL1_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input
connector)
4 SL2_CPU1_PB2 (signal connector on
system board)
CTRL_DST_PA1 (fPERC input
connector)
5 CTRL_SRC_PB1 (fPERC controller
connector)
DST_PA2 and DST_PB2 (backplane
signal connector)
6 CTRL_SRC_PB1 (fPERC controller
connector)
DST_PA2 and DST_PB2 (backplane
signal connector)
7 CTRL_SRC_PA1 (fPERC controller
connector)
DST_PA1 and DST_PB1 (backplane
signal connector)
8 CTRL_SRC_PA1 (fPERC controller
connector)
DST_PA1 and DST_PB1 (backplane
signal connector)
Installing and removing system components 121