Dell PowerEdge R930 - Removing Expansion Cards

Removing an expansion card from expansion card risers
Prerequisites
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Disconnect the cables connected to the expansion card.
4 Remove the expansion card riser.
Steps
1 Slide the expansion card latch.
2 Remove the expansion card from the expansion card riser.
3 If you are removing the card permanently, install a metal ller bracket over the empty expansion slot, and insert the expansion card
latch.
NOTE: You must install a ller bracket over an empty expansion slot to maintain Federal Communications Commission
(FCC) certication of the system. The brackets also keep dust and dirt out of the system and aids in proper cooling and
airow inside the system.
Figure 50. Removing the expansion card (half-length) from the left expansion card riser
1
expansion card (half-length) 2 expansion card latch
Installing and removing system components 109