Dell PowerEdge R930 - Installing a Processor

Figure 72. Removing a processor
1
close rst socket-release lever 2 pin-1 indicator of processor
3 processor 4 slot (4)
5 processor shield 6 open rst socket-release lever
7 socket 8 socket keys (4)
Next steps
1 Replace the processor(s).
2 Install the heat sink.
3 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing a processor
Installing a heat sink
After working inside your system
Installing a processor
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Installing and removing system components 135