Dell PowerEdge R930 - Back Panel Features of the Poweredge R930 System

Back panel features of the PowerEdge R930 system
Figure 4. Back panel features of the PowerEdge R930 system
1 Power supply unit (PSU 3 and 4) 2 PCIe expansion card slots
3 Power supply unit (PSU 1 and 2) 4 Video connector
5 iDRAC Enterprise port 6 Ethernet port (4)
7 USB port (2) 8 Serial connector
9 System identication connector 10 System identication button
Table 3. Back panel features of the PowerEdge R930 system
Item Indicator, Button, or Connector Icon Description
1 Power supply unit (PSU 3 and 4) Up to two redundant AC power supplies with a rating of 750 W or
1100 W
2 PCIe expansion card slots (8 or
10 depending on the I/O risers
installed)
Enables you to connect PCI Express expansion cards.
3 Power Supply Unit (PSU 1 and
2)
Up to two redundant AC power supplies with a rating of 750 W or
1100 W
4 Video connector
Use the video/VGA port to connect a display to the system. For
more information about the supported video/VGA port, see the
Technical specications section.
5 iDRAC Enterprise port
Use the iDRAC8 Enterprise port to remotely access iDRAC. For
more information, see the Integrated Dell Remote Access Controller
User’s Guide at Dell.com/idracmanuals.
NOTE: The port is available for use only if the iDRAC8
Enterprise license is installed on your system.
6 Ethernet port (4)
Use the Ethernet port to connect Local Area Networks (LANs) to
the system. For more information about the supported Ethernet
ports, see the Technical specications section.
About the PowerEdge R930 13