Dell PowerEdge R930 - Installing the Control Panel Board

Steps
1 Remove the screws that secure the control panel board to the chassis.
2 Slide the control panel board toward the back of the system, and remove the control panel board away from the system.
Figure 100. Removing the control panel board
1
screw (2) 2 control panel connector cable
3 display module cable 4 USB connector cable
5 control panel board 6 stando (2)
Next steps
1 Install the control panel board.
2 Reconnect all the cables to the control panel board.
3 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing the control panel board
After working inside your system
Installing the control panel board
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
170
Installing and removing system components