Dell PowerEdge R930 - Psu Specifications

Table 13. Chassis weight
System Maximum weight (with all hard drives/SSDs)
PowerEdge R930
59 kg (130.07 lb)
Processor specications
The PowerEdge R930 system supports two or four Intel E7-8800/4800 v3 or Intel E7-8800/4800 v4 product family processors.
PSU specications
The PowerEdge R930 system supports up to four AC redundant power supply units (PSUs).
Table 14. PSU specications
PSU Class Heat dissipation
(maximum)
Frequency Voltage
750 W AC Platinum 2891 BTU/hr 50/60 Hz 100–240 V AC, autoranging
1100 W AC Platinum+ 4100 BTU/hr 50/60 Hz 100–240 V AC, autoranging
NOTE: Heat dissipation is calculated using the PSU wattage rating.
NOTE: This system is also designed to connect to the IT power systems with a phase-to-phase voltage not exceeding 230 V.
System battery specications
The PowerEdge R930 system supports 3 V CR2032 Lithium coin cell system battery.
Expansion bus specications
The PowerEdge R930 system supports PCI express (PCIe) Generation 3 expansion cards, which need to be installed on the system board
using expansion card risers. This system supports three types of expansion card risers. The following table provides the expansion card riser
specications:
Table 15. Expansion card riser
specications
Expansion card riser PCIe slots on the riser Height Length Link
Riser 1 (NDC riser default) Slot 2 full-height half-length x8 link
Riser 2 (optional) Slot 1/1 full-height full-length x4
Slot 2/2 full-height half-length x4
Slot 3 full-height half-length x8
Slot 4 full-height full-length x16
Slot 5 full-height half-length x16
Slot 6 full-height half-length x16
Slot 7 full-height half-length x16
Slot 8 full-height half-length x16
Riser 3 (optional) Slot 1/9 full-height full-length x8
Slot 2/10 half-height half-length x8
Technical specications 25