Dell PowerEdge R930 - Installing Expansion Card Riser Blanks

3 right riser blank 4 chassis
Next steps
1 Install the left or right expansion card riser.
2 Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing the left or right expansion card riser blank
After working inside your system
Installing the left or right expansion card riser blank
Prerequisites
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
Steps
1 Align the left riser blank with the corresponding slot on the back of the chassis.
2 Press and slide the blank to the right to lock the blank in place.
3 Replace the PCI retention rocker.
Figure 47. Installing the left or right expansion card riser blank
1
left riser blank 2 release tab on the PCI retention rocker
Installing and removing system components 105