Dell PowerEdge R930 - Removing the Optional Internal Dual SD Module

Steps
1 Locate the SD card connector on the internal dual SD module. Orient the SD card appropriately and insert the contact-pin end of the
card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2 Press the card into the card slot to lock it into place.
Figure 65. Installing an internal SD card
1
IDSDM 2 SD card 2
3 SD card 1 4 SD card slot 1
5 SD card slot 2
Next step
Related links
Safety instructions
Before working inside your system
After working inside your system
Removing the optional internal dual SD module
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 If installed, remove the SD cards.
126
Installing and removing system components