Dell PowerEdge R930 - Page 76

WARNING: The memory modules are hot to touch for some time after the system has been powered down. Allow the memory
modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components or
metallic contacts on the memory module.
CAUTION: To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied.
Remove memory module blanks only if you intend to install memory modules in those sockets.
Steps
1 To open the memory riser, open the ip out brackets on the memory riser.
Figure 22. Opening the memory riser
1
memory riser 2 ip out bracket (2)
3 memory riser handle
2 Locate the appropriate memory module socket.
3 To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module socket.
NOTE
: Handle each memory module only by the card edges, making sure not to touch the middle of the memory module or
metallic contacts.
4 Lift the memory module away from the system.
76
Installing and removing system components