Adding and Replacing Parts 151
FILE LOCATION: C:\Projects\Spears\SpearsHTML\parts.fm
DELL CONFIDENTIAL – PRELIMINARY 7/18/07 - FOR PROOF ONLY
Replacing Mini-Card
NOTICE: The connectors are keyed to ensure correct insertion. If you feel
resistance, check the connectors on the card and on the system board, and realign
the card.
NOTICE: To avoid damage to the Mini-card, never place cables under the card.
1
Insert the card connector into the system board connector at a 45-degree
angle.
2
Press the other end of the card down into the slot on the system board
until the card clicks into place.
3
Replace the securing screw.
4
Connect the cables to the Mini-Card, ensuring that you route the cables
correctly.
NOTE: For more specific information about which cable to connect to which
connector, see the documentation that came with your Mini Card.
5
Secure unused antenna cables in the protective mylar sleeve.
6
Replace the cover and tighten the five captive screws.
1 Mini-card
1
To Next Page
Loading...
