2. Remove the computer cover (see Removing the Computer Cover).
3. Rotate the hard-drive carrier out of the computer (see Rotating the Hard-Drive Carrier Out of the Computer).
4. If you are replacing a memory module, see Removing Memory.
5. Press out the securing clip at each end of the memory module connector.
6. Align the notch on the bottom of the module with the crossbar in the connector.
7. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
8. Rotate the hard-drive carrier back into place (see Rotating the Hard-Drive Carrier Back into the Computer).
9. Replace the computer cover (see Replacing the Computer Cover).
10. Connect your computer and devices to electrical outlets, and turn them on.
CAUTION: Fully-buffered memory modules may become very hot during normal operation. Ensure that memory modules have had sufficient time
to cool before you touch them.
To Next Page
Loading...
Need help?
General