11. Press <F2> to enter the system setup program and check the values listed under Memory Info.
The computer should have changed the value of Installed Memory to reflect the newly installed memory. Verify the new total. If it is correct, skip to
step13.
12. If the memory total is incorrect, turn off and disconnect your computer and devices from their electrical outlets.
Return to step1 of this procedure, but instead of installing new memory, check the installed memory modules to ensure that they are seated properly in
their sockets.
13. When the Installed Memory total is correct, press <Esc> to exit system setup.
14. Run the Dell Diagnostics (see Dell Diagnostics) to verify that the memory modules are operating properly.
Back to Contents Page
To Next Page
Loading...
