Dell Storage Center SCv2020 User Manual

Figure 84. Reconnecting the A-Side Cable to the Remaining Expansion Enclosure
1. Storage system
2. Storage controller 1
3. Storage controller 2 4. Expansion enclosure 1
5. Expansion enclosure 2
Disconnect the SC100/SC120 Expansion Enclosure from the B-Side of the
Chain
Disconnect the B-side cables from the expansion enclosure that you want to remove.
1. Disconnect the B-side cable (shown in blue) from expansion enclosure 1: bottom EMM, port A. The
A-side cables continue to carry IO while the B-side is disconnected.
2. Remove the B-side cable between expansion enclosure 1: bottom EMM, port B and expansion
enclosure 2: bottom EMM, port A.
Adding or Removing an Expansion Enclosure
105

Dell Storage Center SCv2020 Specifications

General

Form Factor	2U
RAID Support	RAID 0, 1, 5, 6, 10
Controllers	Dual Controllers
Host Connectivity	iSCSI, Fibre Channel
Product Type	Storage Array
Storage Type	SAN
Management Software	Dell Storage Manager
Processor	Intel Xeon
Maximum Raw Capacity	480 TB
Power Supply	Dual
Protocols	iSCSI, Fibre Channel
Max Storage	480 TB
Drive Type	SSD, HDD
Drive Types Supported	SSD
Operating Temperature	10° to 35°C (50° to 95°F)
Host Interface	8/16 Gb Fibre Channel, 10 Gb iSCSI
Host Port Speed	8/16 Gb Fibre Channel, 10 Gb iSCSI