4. From the Storage tab navigation pane, select the Volumes node.
5. Select the volumes to delete.
6. Right-click on the selected volumes and select Delete. The Delete dialog box appears.
7. Click OK
Send Diagnostic Data Using Dell SupportAssist
Use Dell SupportAssist to send diagnostic data to Dell Technical Support Services.
1. Click Send SupportAssist Data Now. The Send Support Assist Data Now dialog box appears.
2. Select Storage Center Configuration and Detailed Logs.
3. Click OK.
Label SC100/SC120 Expansion Enclosures
SC100/SC120 expansion enclosures do not have displays to indicate the expansion enclosure ID assigned
by Storage Center.
About this task
To facilitate easy identification in the rack, use the Dell Storage Client to match each expansion enclosure
ID to a Service Tag. Locate the Service Tag on the back of each expansion enclosure and then label it
with the correct expansion enclosure ID.
NOTE: If the expansion enclosure is deleted from the Storage Client and then added back in, the
expansion enclosure is assigned a new index number, which requires a label change.
Steps
1. Click the Hardware tab.
2. In the Hardware tab navigation pane, select the Enclosures node.
3. In the right pane, locate the enclosure to label and record the Service Tag.
4. Create a label with the enclosure ID.
NOTE: For example, if the name of the enclosure is Enclosure - 2, the enclosure ID is 2.
5. Locate the expansion enclosure with the recorded Service Tag and apply the ID label to the front left
of the enclosure.
Perform Post-Setup Tasks
91
To Next Page
Loading...
Need help?
General
