Dell Storage Center SCv2020 User Manual

5
Discover and Configure the Storage
Center
The Discover and Configure Uninitialized SCv2000 Series Storage Centers wizard allows you to set up a
Storage Center to make it ready for volume creation.
Use the Dell Storage Client to discover and configure the Storage Center. After configuring a Storage
Center, you can set up a localhost, VMware vSphere host, or VMware vCenter host using the host setup
wizards.
The storage system hardware must be installed and cabled before the Storage Center can be configured.
Locating Your Service Tag
Your storage system is identified by a unique Service Tag number.
You can find the Service Tag number on the service luggage tag located next to the front panel display.
The Service Tag number is also located on the back of the storage system chassis. Dell uses this
information to route support calls to the appropriate personnel.
Figure 69. Service Tag Locations
1. Service luggage tag 2. Service Tag label
Discover and Configure the Storage Center
77

Dell Storage Center SCv2020 Specifications

General

Form Factor	2U
RAID Support	RAID 0, 1, 5, 6, 10
Controllers	Dual Controllers
Host Connectivity	iSCSI, Fibre Channel
Product Type	Storage Array
Storage Type	SAN
Management Software	Dell Storage Manager
Processor	Intel Xeon
Maximum Raw Capacity	480 TB
Power Supply	Dual
Protocols	iSCSI, Fibre Channel
Max Storage	480 TB
Drive Type	SSD, HDD
Drive Types Supported	SSD
Operating Temperature	10° to 35°C (50° to 95°F)
Host Interface	8/16 Gb Fibre Channel, 10 Gb iSCSI
Host Port Speed	8/16 Gb Fibre Channel, 10 Gb iSCSI