Name: Dell Storage Center SCv2020
Brand: Dell
Rating: 4 (1 reviews)

To Next Page

To Previous Page

NOTE: After the Storage Center configuration is complete, run the host access wizard to configure

host server access and apply MPIO best practices. For the latest best practices, see the Dell Storage

Center Best Practices document on the Dell TechCenter site (http://en.community.dell.com/

techcenter/storage/).

Labeling the Front-End Cables

Label the front-end cables to indicate the storage controller and port to which they are connected.

Prerequisites

Locate the pre-made front-end cable labels that shipped with the storage system.

About this task

Apply cable labels to both ends of each cable that connects a storage controller to a front-end fabric or

network, or directly to host servers.

Steps

1. Starting with the top edge of the label, attach the label to the cable near the connector.

Figure 51. Attach Label to Cable

2. Wrap the label around the cable until it fully encircles the cable. The bottom of each label is clear so

that it does not obscure the text.

Figure 52. Wrap Label Around Cable

3. Apply a matching label to the other end of the cable.

Connect the Front End

Dell Storage Center SCv2020 Specifications

General

Dell Storage Center SCv2020 User Manual

Other manuals for Dell Storage Center SCv2020