Installing the speaker module
1. Insert the speaker module into the slot on the chassis.
2. Tighten the screws to secure the speaker to the chassis.
3. Secure the speaker cables through the retention clips.
4. Connect the speaker cable to the connector on the system board.
5. Install the:
a. system board shield
b. speaker cover
c. back cover
d. cable cover
e. stand
6. Follow the procedure in After working inside your computer.
Display panel
Removing the display panel
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. stand
b. back cover
c. cable cover
d. speaker cover
e. speaker
f. hard drive
g. optical drive
h. VESA mount bracket
i. system board shield
j. SSD card
k. WLAN card
l. memory
m. heat sink
n. system fan
o. processor
p. coin cell battery
q. power supply unit
r. system board
s. chassis frame
3. To remove the display panel:
a. Remove the screws that secure the display panel to the bezel.[1].
b. Lift the display panel away from the bezel. [2].
Disassembly and reassembly
27
To Next Page
Loading...
