Installing the intrusion switch
1. Place the intrusion switch in the slot on the computer.
2. Tighten the screw to secure the intrusion switch to the chassis.
3. Route intrusion switch cable along the retention clips on the chassis.
4. Connect the intrusion switch cable to the connector on the system board.
5. Install:
a. VESA mount bracket
b. power supply unit
c. system board shield
d. speaker cover
e. cable cover
f. back cover
g. stand
6. Follow the procedures in After working inside your computer.
Power and On-Screen Display buttons board
Removing the On-Screen Display- OSD buttons board
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. stand
b. back cover
c. optical drive
3. To remove the OSD buttons board:
a. Remove the screw to remove the metal plate that secures the OSD buttons board to the computer [1].
b. Peel off the tape from the OSD buttons board [2].
c. Remove the OSD buttons board from the chassis.
d. Disconnect the cables from the OSD buttons board to release the board from the computer [3].
38
Disassembly and reassembly
To Next Page
Loading...
