Switch Management 85
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\Dell Astute\User
Guide\Dell_Astute_SwitchManagement.fm
DELL CONFIDENTIAL – PRELIMINARY 8/9/16 - FOR PROOF ONLY
3
Enter the following
IP Format
fields:
–
Supported IP Format
— Select whether IPv4 or IPv6 format is
supported.
–
IPv6 Address Type
— When the server supports IPv6, this specifies
the type of static address supported. The possible options are:
•
Link Local
— A Link Local address that is non-routable and used
for communication on the same network only.
•
Global
— A globally unique IPv6 address; visible and reachable
from different subnets.
4
Enter the following
File Type and Protocol
fields:
–
File Type
— Select the type of files to be downloaded to the device.
The possible options are:
•
Firmware Download
— A firmware file is downloaded.
•
Configuration Download
— A configuration file is downloaded.
–
Update Method
— Select the download method to be used. The
possible options are:
•
HTTP
— Download file using HTTP
•
TFTP
— Download file using TFTP
•
USB
— Download from a USB drive
•Flash
— Download from Flash memory
–
Server IP Address
— Enter server address where the file to be
downloaded is stored.
–
Source File Name
— Enter the name of the file to be downloaded.
–
Destination File Type
— Name of type of file to be downloaded. The
possible options are:
•
Software Image
— Downloads the image file. The image file
overwrites the non-active image. It is recommended to designate
that the non-active image becomes the active image after reset,
and then to reset the device following the download. During the
Image file download a dialog box opens that displays the
download progress, and browsing is disabled.
•
Boot Code
— Downloads the boot file.
To Next Page
Loading...
