Product Handling Multec 3.5 Fuel Injector Application Manual
6-4 Delphi Energy and Chassis Systems
Revision: 11/05-1
Caution
Injector packaging designs must provide adequate environmental
protection to the injector taking into consideration the intended shipping
method. Requirements include
• Protection from vibration and shock
• Protection from external contamination
• Protection from shipping material generated contamination
6.2 Receiving and Storage
The condition of each pallet or shipping container should be checked on
receipt. Check the label attached to the pallet to verify the model number.
Report any damage to Delphi.
Store the injector in a cool, dry, dust-free environment. Do not store
injectors, rail assemblies, engines or partially assembled vehicles in an
unprotected environment.
Caution
The Multec 3.5 Fuel Injector should never be exposed to liquid
contamination. Should water enter the injector’s solenoid assembly
through the connector, fuel inlet or injector tip, damage could occur.
6.3 Movement Within the Plant
Exercise care to prevent damage and contamination when injectors are
transported from storage to production lines or staging areas.
6.4 Installation in Fuel Rail
The injector should be installed in the fuel using the surface indicated in
Figure 6-2. The injector tip should not be used for installation. The
injector and socket axes should be aligned for installation using proper
fixturing. Inadequate alignment will result in difficult assembly and
possible damage to the injector seal ring or socket. Reference section 4.3
and Table 6-2 for seal ring installation lubrication requirements.
To Next Page
Loading...
Need help?
General