Delphi Multec 3.5 User Manual

Multec 3.5 Fuel Injector Application Manual Introduction
Delphi Energy Chassis Systems Revision: 11/05-1 1-5
Note: Unless otherwise noted, the numbered figures displayed in this
manual are illustrations, not technical drawings. As such, these
illustrations may not reflect actual dimensions. All final critical
dimensions should be confirmed on part prints.
1.8 Hyperlinks
All references to section numbers, figures and tables are hyperlinks that
will jump to the section of the document containing the reference when
the mouse is left clicked over the reference number. (Applies only to
WORD version of the applications manual.)
1.9 Applicable Documents
1.9.1 Order of Precedence
When there appears to be a contradiction between this application manual
and an outline drawing or other document, the conflict must be formally
resolved through the Delphi application engineer. Until the contradiction
can be resolved, the part outline drawing will always take precedence.
Nothing in this document shall be considered to supersede any applicable
law or regulation unless a specific exemption has been obtained.
1.9.2 Government Documents
To be supplied by customer for specific country.
1.9.3 Other Delphi Reference Documents
1.9.3.1 Multec 3.5 Fuel Injector specific Part Number and associated outline drawing
1.9.3.2 Multec 3.5 Fuel Injector Component Technical Specification (or equivalent document) if
available
1.9.3.3 Delphi Fuel Rail Applications Manual
1.9.3.4 Delphi Catalytic Converter Applications Manual
1.9.3.5 Delphi Fuel Pump Applications Manual
1.9.3.6 Delphi EGR Applications Manual
1.9.3.7 SFMEA
1.9.3.8 OBD-II Diagnostic Procedures
1.9.3.9 Delphi Worldwide Emissions Standards summary booklet

Delphi Multec 3.5 Specifications

General

Brand	Delphi
Model	Multec 3.5
Category	Laboratory Equipment
Language	English