Ethernet Communication Module IFD9506
DVP-PLC Operation Manual
5.3 E-Mails Setting
E-Mail is the abbreviation of electronic mail which transmits mails through the network. IFD9506 has E-Mail
functions for the user to pre-save a segment of text message, which can be a descriptive message or error
message, into the subject of the E-Mail. When the E-Mail is triggered, IFD9506 will send the messages to t
he
us
er by E-Mail.
1. Mail alarm setup:
There are 3 mail alarms to be set. Check the boxes to enable the alarms. The alarm can be triggered by
“low" and “high”.
2. SMTP server:
When Alarm 1 is triggered, the E-Mail will first be sent to SMTP server, and SMTP server will send it to th
e
des
ignated address. For example, assume there is an E-Mail to be sent to Test@delta.com.tw
, and SMTP
server is 192.168.0.1, the E-Mail will be sent to SMTP server first, and the server will further send it to the
recipient
Test1@delta.com.tw.
3. E-Mail of sender:
The email source.to let the recipient know the sender of the email; maximum 63 English characters
allowed.
4. Subject of E-Mail:
You can enter the text message in the column, and the message will be placed in the subject of the E-Ma
il
and s
ent to the recipient. IFD9506 is able to contain 1~3 E-Mail subjects. Max. 63 English characters ar
e
al
lowed for each subject.
5. E-Mail of recipient:
One mail can be sent to 10 addresses according to the alarm setting. Every address allows Max. 6
3
E
nglish characters. For example, when Alarm 1 is triggered, the E-Mail will be sent to Test1@delta.com.tw
.
When Alarm 2 is triggered, the E-Mail will be sent to Test2@delta.com.tw.
Notes:
(1) To correctly send out E-Mails, there has to be a SMTP server in the network. When we send out an
E-Mail, the mail will be sent to SMTP server first, and the server will further send the mail to the
designated address.
(2) The mail function of IFD9506 does not support the mail server that requires an account and password
,
nor
support encryption protocols like SSL, TLS.
5.4 Monitoring Settings
You can read data in designated addresses via a serial port only by using the Modbus protocol in the serial
master mode. The data can be temporarily stored in IFD9506 for the purpose of fast storing and acquisition.
To Next Page
Loading...
Need help?
General