Chapter 10 Digital KeypadC2000
10-12
Choose 0: Normal load or 1: Heavy load based on the needs, then press
ENTER.
4. Changed List
This function displays the parameter that user has set.
For example:
Set Pr. 13-00 Application Selection = 3: Fan
Enter the changed list screen. List PrNum=026 means there are 26
parameters that have been changed.
Press ENTER to enter the changed list screen.
Use Up/ Down key to select the parameters that need
to be checked or changed.
Press ENTER to enter the parameter.
5. Copy Parameter
Press ENTER key to go to 001~004:
content storage
4 duplicates are provided
The steps are shown in the example below.
Example: Saved in the motor drive.
1 Go to “Copy Parameter”
2 Select the parameter group which needs to
be copied and press ENTER key.
To Next Page
Loading...
