Delta C2000 Series User Manual

Chapter 12 Description of Parameter SettingsC2000
12.1-00-15
 Determines how the motor is stopped when the AC motor drive receives the STOP command.
1. Ramp to stop: the AC motor drive decelerates to 0 or the minimum output frequency (Pr. 01-07)
according to the set deceleration time, and then to stop.
2. Coast to stop: the AC motor drive stops output immediately, and the motor coasts to stop
according to the load inertia.
 Use “ramp to stop” for the safety of personnel, or to prevent material from being wasted in
applications where the motor must stop immediately after the drive stops. You must set the
deceleration time accordingly.
 If idling is allowed, or the load inertia is large, use “coast to stop”. For example, blowers,
punching machines and pumps

Control of Motor Direction
Default: 0
Settings 0: Enable forward/ reverse
1: Disable reverse
2: Disable forward
 Enable the AC motor drives to run in the forward / reverse direction. You can use it to prevent a
motor from running in a direction that would cause injury or damage the equipment.
Digital Keypad Frequency Command Memory
Default: Read Only
Settings Read only
 If the keypad is the frequency command source, when Lv or Fault occurs, the parameter stores
the current frequency command.

User-Defined Characteristics
Default: 0
Settings
bit0–3: user-defined decimal places
0000b: no decimal place
0001b: one decimal place
0010b: two decimal places
0011b: three decimal places

Delta C2000 Series Specifications

General

Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 60°C
Overload Capacity	150% of rated current for 60 seconds
Communication	DeviceNet
Protection	Overvoltage, Undervoltage, Overcurrent, Overload, Overheat
Humidity	5% to 95% (non-condensing)
Cooling	Forced air cooling
Control Mode	V/F Control, Sensorless Vector Control