Delta C2000 Series User Manual

Chapter 12 Description of Parameter SettingsC2000
12.1-02-23

Motor Zero-speed Level
Default: 0
Settings 0~65535 rpm
 This parameter should be used with the multi-function output terminals (set to 43). It needs to be
used with PG card and motor with encoder feedback.
 Use this parameter to set the level of motor at zero-speed. When the speed is lower than this
setting, the corresponding multi-function output terminal that is set to 43 is ON, as shown below:

Maximum Frequency of Resolution Switch
Default: 60.00
Settings 0.00~599.00Hz

Switch delay time of Maximum output frequency
Default: 0.000
Settings 0~65.000 sec.
 Use to improve unstable speed or unstable position due to insufficient analog resolution. Use with
the external terminal (setting to 43). After setting this parameter, you also need to adjust the
analog output resolution of the controller so as to work with the parameter function.

Delta C2000 Series Specifications

General

Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 60°C
Overload Capacity	150% of rated current for 60 seconds
Communication	DeviceNet
Protection	Overvoltage, Undervoltage, Overcurrent, Overload, Overheat
Humidity	5% to 95% (non-condensing)
Cooling	Forced air cooling
Control Mode	V/F Control, Sensorless Vector Control